Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
GAF Construction in Lompico, CA | Moreno Valley Builders
We provide independent GAF roof replacement, repair, and storm-damage service throughout Lompico, CA. The thing that separates our GAF work here isn’t the shingle, it’s the sequencing: narrow private roads on steep canyon lots usually block full-size delivery rigs, so we plan every tear-off around smaller shuttle trucks and hand-staging instead of a dropped conex at the curb. If you’re researching GAF roofs for a Lompico home built between 1940 and 1980, call (877) 752-3154 and we’ll talk through what your specific lot and access actually require.
Moreno Valley Builders is a full-scope general contractor led by Noel Trevino. We’ve opened up enough failed GAF assemblies in the Santa Cruz Mountains to know which details hold up to ember seasons and wet El Niño winters, and which ones look fine on a spec sheet but fail up here. As an independent contractor, we install GAF to the manufacturer’s written spec and warranty requirements without any authorization, sponsorship, or warranty endorsement from GAF. That independence is the point: we specify what the site demands, not what a marketing program pushes.
Why Lompico Residents Choose Us for GAF Service
We know GAF’s product line from the deck up, and we know how it behaves in 95005 specifically. Timberline HDZ and UHDZ shingles, Liberty SBS membrane, Pro-Start starter strip, Seal-A-Ridge caps, GAF-approved underlayment: we’ve installed and repaired all of it. When a General Contractor in Lompico like us gets a call about granule loss or a wind-lifted tab, we already have a working theory about what’s underneath before we put a ladder on the fascia. Noel spent the better part of three decades building and renovating homes across the Inland Empire before bringing that trade knowledge into the Santa Cruz Mountains, including the habit of checking what the original builder actually did, not what the permit set says they did. One contractor. Every phase. And when a GAF roof decision has to account for fire-resistant assembly rules, private road access, and canyon drainage at once, the answer comes from the same conversation, not three different crews.
Styles & brands we work with







Common GAF Construction Problems We Solve in Lompico
- Ember intrusion at original ridge and eave vents. On pre-CZU rebuilds, we routinely find gable and soffit vents that were never upgraded to ember-resistant assemblies. Firebrands get driven into those openings during wind events, and that’s the most common GAF roof failure we open up in Lompico. The fix starts at the vent, not the shingle field.
- Granule loss and algae streaking from the canyon’s damp fog belt. Lompico’s heavy conifer canopy keeps shingle surfaces wet and shaded far longer than open, sun-blasted roofs. That moisture accelerates granule shed and feeds the dark streaking. A GAF roof up here works harder than the same roof two ridges over with full sun exposure.
- Wind-lifted tabs and failed ridge caps. Winter storm gusts funnel right up the canyon and catch GAF shingle tabs on older roofs. Where a 1940s or 1960s deck was nailed originally with a sparse pattern, we re-nail before the new field goes down. Skipping that step guarantees the next failure.
- Deck and flashing rot at roof-to-wall and roof-to-gutter transitions. Steep-slope runoff wicks into redwood fascia around Lompico chimneys, dormers, and gutters. Homeowners often see interior water stains long before the shingle field looks worn. We open it up, dry it out, and rebuild the transition with GAF-approved flashing details.
- Whole-deck replacement on post-CZU rebuilds that cut corners. We’ve pulled apart 1990s-era rebuilds off Lompico Road with ember-scorched underlayment still in place and decking that shouldn’t have been shingled over. Reusing a compromised deck under a new GAF roof voids the system before the first winter rain.
GAF Service in Lompico: What Local Conditions Mean for Your Equipment
Here’s the part most roofing pages skip. Lompico sits in a remote, heavily wooded canyon where almost every construction project runs into the same three walls: narrow, winding private roads that block concrete trucks and full-size delivery rigs; steep, fire-prone slopes that trigger defensible-space and Class A assembly requirements; and a post-CZU rebuild landscape where older redwood cabins got patched rather than properly re-roofed. That combination changes how a Brookdale GAF service or similar mountain job gets sequenced. On a recent steep cabin lot off Lompico Road, a full-size delivery truck simply couldn’t make the private grade. We shuttled bundles up in a smaller truck, hand-staged them at the ridge, and kept the debris bin at the bottom of the drive. The tear-off took longer, but the staging was right. Where garage and soffit vents were original from the 1960s and never upgraded after CZU, we didn’t bury them under new shingles; we swapped in ember-resistant assemblies first, because a Class A GAF field over a vent that breathes firebrands isn’t a Class A roof. If the details aren’t right on paper, they won’t be right in the wall.
GAF Models & Products We Service in Lompico
We install and repair the GAF lines that fit Santa Cruz Mountains conditions: Timberline HDZ architectural shingles, Timberline UHDZ for deeper shadow lines and higher wind ratings, GAF Liberty SBS self-adhered membrane for low-slope sections and porch returns, plus Pro-Start starter strip and Seal-A-Ridge ridge cap on every full replacement. Our parts stance is simple: genuine GAF components only. Mixing generic starter or ridge products into a warranted GAF assembly is exactly what voids the coverage. For fast Lompico turnaround, we keep common GAF flashing details and accessory stock staged on the truck so a small repair doesn’t wait on a supplier run down the hill. See our broader GAF sales & service page for the full product scope we handle.
See the difference
Before
After
Before
After
Before
AfterGAF Service Pricing in Lompico
What you’ll pay depends on access, deck condition, and whether we’re repairing one failure or replacing the whole system. Here are the ranges we quote across the 95005 canyon:
| Service | Price Range |
|---|---|
| Roof Repair | $400 – $1,800 |
| Roof Replacement | $8,000 – $20,000 |
| Metal Roof Installation | $15,000 – $40,000 |
A repair is the right call when the deck and flashing are sound. We only recommend a full re-roof when the deck, underlayment, or venting has actually failed. Call (877) 752-3154 for a written line-item quote, not a rough guess over the phone.
Serving Lompico, CA — Our Local Coverage Area
We’re based in the Lompico area and know this community well, offering GAF service in Felton and surrounding canyons. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs – GAF Construction in Lompico
Often, no. Full-size delivery rigs and concrete trucks routinely can’t make the private grades in Lompico, so we shuttle bundles up in smaller trucks and hand-stage them. We’ll assess your road access before we schedule, and that’s built into the estimate. Call (877) 752-3154 for a quote that accounts for your actual drive.
Yes, and not just technically. Lompico’s post-CZU rebuilds fall under wildfire-resistant construction rules that include Class A assemblies and ember-resistant venting. A Mount Hermon GAF service-grade Timberline HDZ field with Pro-Start and Seal-A-Ridge over the right underlayment gets you there, but the venting has to be upgraded too. We won’t shingle over old ember-susceptible vents.
Lompico’s conifer canopy keeps shingle surfaces wet and shaded far longer than open roofs, which accelerates granule loss and algae streaking. It’s a canyon moisture problem, not a manufacturing defect. We’ll tell you whether cleaning and spot repair buys you time or whether the deck condition calls for a full replacement.
No, and we won’t. A sparse original nail pattern on a 1940s – 1970s Lompico deck means the whole field has to be re-nailed before a new GAF assembly goes down. Shingling over it guarantees wind-lifted tabs the next storm season. The re-nail is part of our replacement quote.
On a steep, fire-exposed Lompico slope, a standing-seam metal roof in the $15,000 – $40,000 range can be the better long-term call because it carries no combustible surface for firebrands to catch. GAF shingles with a Class A assembly still protect well, but metal eliminates the ember question entirely. Call (877) 752-3154 and we’ll price both for your specific slope and access.
Service Areas Near Lompico
We serve Lompico and the surrounding canyon and valley communities, including Moreno Valley, March Air Force Base, Loma Linda, Highgrove, and Mead Valley. This covers both the fire-exposed hillside work we do from our Lompico service area base and the flatter, larger-lot jobs we handle in GAF service in Ben Lomond and GAF service in Cambrian Park.
Book Your GAF Service in Lompico Today
Your roof, your material choices. Tell us what you’ve got and what access looks like, and we’ll line-item the rest. Call (877) 752-3154 to schedule a free estimate with Noel and the crew.
Written by Noel Trevino, Owner at Moreno Valley Builders, serving Lompico and the Santa Cruz Mountains.